Latest topics
» pivot tube
Today at 8:30 pm by ernie

» AMC 250CC CARB
Today at 7:44 pm by MR SINBAD

» VILLIERS 1H
Today at 9:37 am by piston 197

» 8e gear lever
Yesterday at 1:45 pm by kerabo

» help wanted
Tue Jan 16, 2018 8:20 pm by Dickey0-1

» Cruiser 75 Generator Coils
Tue Jan 16, 2018 7:38 pm by peter@dunfordconstruction

» ITEMS FOR SALE OR WANTED
Mon Jan 15, 2018 6:31 pm by bill2b

» Contact breaker screw
Mon Jan 15, 2018 4:30 pm by kerabo

» Pub meet FFOC welcome
Mon Jan 15, 2018 3:32 pm by kerabo


Clutch bolts Plover 147cc 30c

View previous topic View next topic Go down

Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 10:25 am

Hi folks the rebuild is going well, have new Bonded clutch plates from Villiers, just fitting the 6bolts and springs but cannot find anything about how tight to do them up, any ideas?
Cheers
Bill
avatar
bill2b

Posts : 54
Join date : 2017-09-26

Back to top Go down

Clutch adjustment

Post  piston 197 on Mon Oct 30, 2017 12:43 pm

The screws should go fully in and be tightened, this may cause the clutch to drag, if the plates have been corked with thick corks !, but better than leaving them loose as they will work out and form a gouge or deep radial groove in the inner chaincase or worse !
Best to use automatic gearbox fluid in the clutch case ( TQF/ATF)
JH
avatar
piston 197
Moderator

Posts : 3717
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 1:01 pm

Thanks John, the plates are bonded not corked so will the same apply re the tightening and tqf? Ta
avatar
bill2b

Posts : 54
Join date : 2017-09-26

Back to top Go down

clutch

Post  piston 197 on Mon Oct 30, 2017 1:22 pm

Yes screws have to be fully home and locked or they will gradually work themselves out and hit the inner case, TQF is fine with bonded plates, it is the set up I always ran on my Villiers engine trials bikes and they get a lot more stick than you are going to do .
JH
avatar
piston 197
Moderator

Posts : 3717
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 1:53 pm

Thanks John, gteat help as usual.
avatar
bill2b

Posts : 54
Join date : 2017-09-26

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum