Latest topics
» Falcon 67 Parts
Today at 12:05 pm by fulmar88

» Wanted Scrap Rear Sprocket
Today at 11:50 am by kerabo

» F/B 1957 Cruiser 75 Carbs
Today at 11:11 am by peter@dunfordconstruction

» Fuel Stabiliser
Today at 6:59 am by piston 197

» cruiser 80 brakes
Yesterday at 9:25 am by Miday

» oil seals for mid 50s rear shocks
Sun Feb 18, 2018 9:07 pm by bill2b

» oil seals for mid 50s rear shocks
Sun Feb 18, 2018 7:37 pm by bill2b

» More carb problems
Sun Feb 18, 2018 7:26 pm by Sgtbiro

» trials shake down run( a few teething problems) bike and rider
Sun Feb 18, 2018 7:26 pm by denman


Wiring for AMC trials

Page 2 of 2 Previous  1, 2

Go down

Re: Wiring for AMC trials

Post  woodenhead on Fri Sep 29, 2017 6:21 pm

Hi
In case your thinking you can use your original coils they will not do what the completion coils will do.
They are specifically designed to do the ignition only and the other coils are for lighting.
To check the coils check resistance to make sure there is no open circuit and then if you put a volt meter accros the coil and kick the engine over you should see some movement on the needle.
Regards
Mike d.
avatar
woodenhead

Posts : 253
Join date : 2008-09-08
Age : 75
Location : Berks.

Back to top Go down

Re: Wiring for AMC trials

Post  rob spence on Sat Sep 30, 2017 2:53 pm

Thanks, I just want to test them at this stage before I decide which way to go for ignition...I'm favouring electronic at the moment.

rob spence

Posts : 104
Join date : 2017-03-20

Back to top Go down

Page 2 of 2 Previous  1, 2

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum