Latest topics
» Double lift centre stand
Yesterday at 11:22 pm by intrudin

» New Francis Barnett
Yesterday at 10:21 pm by John Wakefield

» Best Oil to use
Yesterday at 10:16 pm by John Wakefield

» Plover Wiring
Yesterday at 7:27 pm by Rex Stewart

» Rear suspension
Yesterday at 5:25 pm by piston 197

» WELCOME TO THE FBOC FORUM
Yesterday at 4:34 pm by kerabo

» Newbie Here
Sat Jan 20, 2018 9:16 pm by MoscowFlyer

» Villers 14A seagul engine HELP
Sat Jan 20, 2018 8:14 am by JonTheBuilder

» pivot tube
Fri Jan 19, 2018 5:54 pm by ernie


Wiring for AMC trials

Page 2 of 2 Previous  1, 2

View previous topic View next topic Go down

Re: Wiring for AMC trials

Post  woodenhead on Fri Sep 29, 2017 6:21 pm

Hi
In case your thinking you can use your original coils they will not do what the completion coils will do.
They are specifically designed to do the ignition only and the other coils are for lighting.
To check the coils check resistance to make sure there is no open circuit and then if you put a volt meter accros the coil and kick the engine over you should see some movement on the needle.
Regards
Mike d.
avatar
woodenhead

Posts : 253
Join date : 2008-09-08
Age : 75
Location : Berks.

Back to top Go down

Re: Wiring for AMC trials

Post  rob spence on Sat Sep 30, 2017 2:53 pm

Thanks, I just want to test them at this stage before I decide which way to go for ignition...I'm favouring electronic at the moment.

rob spence

Posts : 99
Join date : 2017-03-20

Back to top Go down

Page 2 of 2 Previous  1, 2

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum