Latest topics
» F B Spares
Yesterday at 9:01 pm by bill2b

» Cruiser 89 air filter for Viliers 4T engine
Yesterday at 4:39 pm by piston 197

» Fulmar Speedo on ebay
Yesterday at 12:59 pm by fulmar88

» What's this from
Yesterday at 10:09 am by john87

» tank badge fixing screws
Yesterday at 1:39 am by intrudin

» Plover with Engine Number 12T 5090
Mon Nov 20, 2017 8:49 pm by Farley

» wheel nut
Mon Nov 20, 2017 11:30 am by alan67

» Fuel Tank cap
Sun Nov 19, 2017 9:00 pm by bill2b

» Age etc of plover please?
Sun Nov 19, 2017 6:57 pm by piston 197


AMC gudgeon pin removal

View previous topic View next topic Go down

AMC gudgeon pin removal

Post  rob spence on Sun Aug 20, 2017 10:32 am

Does anyone know the correct proceedure for removing the gudgeon pin on the AMC V20TS engine please?

rob spence

Posts : 82
Join date : 2017-03-20

Back to top Go down

Gudgeon pin removal

Post  piston 197 on Sun Aug 20, 2017 10:53 am

First place a rag in the crankcase mouth so nothing drops in ,Remove one circlip, warm up the piston with a heat gun , push pin out, if piston is not on a rod , then dipping in hot water will do !

JH
avatar
piston 197
Moderator

Posts : 3625
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: AMC gudgeon pin removal

Post  rob spence on Sun Aug 20, 2017 1:04 pm

Thanks JH...wasn't sure if they were a conrod gripped pin or not as there were no circlips fitted. All is now clear!

rob spence

Posts : 82
Join date : 2017-03-20

Back to top Go down

pin fit

Post  piston 197 on Sun Aug 20, 2017 1:35 pm

They should be floating in the small end bush and light interference fit in the piston, Modern car technology is as you describe, and i have removed these, but you need to heat the conrod eye and press them out, changed a lot of these when cars filled with water in floods and bent the rods, but with this car type you always have the rod off the engine when you have to remove the piston.
Presumably someone has started the job for you and removed the clips, because if it was run like this, as soon as the piston got hot ,the pin would have moved and snagged the transfer ports
JH
avatar
piston 197
Moderator

Posts : 3625
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: AMC gudgeon pin removal

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum