Latest topics
» Double lift centre stand
Yesterday at 11:22 pm by intrudin

» New Francis Barnett
Yesterday at 10:21 pm by John Wakefield

» Best Oil to use
Yesterday at 10:16 pm by John Wakefield

» Plover Wiring
Yesterday at 7:27 pm by Rex Stewart

» Rear suspension
Yesterday at 5:25 pm by piston 197

» WELCOME TO THE FBOC FORUM
Yesterday at 4:34 pm by kerabo

» Newbie Here
Sat Jan 20, 2018 9:16 pm by MoscowFlyer

» Villers 14A seagul engine HELP
Sat Jan 20, 2018 8:14 am by JonTheBuilder

» pivot tube
Fri Jan 19, 2018 5:54 pm by ernie


Villiers X1VA Engine

View previous topic View next topic Go down

Villiers X1VA Engine

Post  Maurice on Sun Aug 13, 2017 4:01 pm

I am trying to remove the primary chain sprocket from the crankshaft of Villiers XIVA engine.
Can someone please confirm it is a taper fit and in theory should come off with the aid of a puller?
Also what is the role of the disc with cut outs for a C spanner behind the two pulleys?
Picture attached.

Maurice

Maurice

Posts : 88
Join date : 2010-05-08

Back to top Go down

Villiers XIVA Engine

Post  Maurice on Sun Aug 13, 2017 4:06 pm

Another attempt at the picture

Maurice

Posts : 88
Join date : 2010-05-08

Back to top Go down

Sprocket removal

Post  piston 197 on Sun Aug 13, 2017 4:36 pm

"the engine and dynamo sprockets are screwed by means of left-hand thread to a duplex sprocket adapter. To gain access to these sprockets, first remove the crankshaft outside nut by means of it's
right hand thread, again using engine compression as resistance. The special hammertite spanner is recommended for this purpose. Now with an ordinary puller withdraw the adapter assembly from the shaft. it is secured by a plain taper only. Hold the removed assembly in the vice, remove the lock ring, by it's left-hand thread and deal similarly with the dynamo sprocket, then remove the distance piece, the drive sprocket can now be unscrewed from adapter ( left-hand thread) "

you can see from above the slotted ring you refer to is the lock nut that holds the sprockets onto the adapter

JH
avatar
piston 197
Moderator

Posts : 3721
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Villiers XIVA Engine

Post  Maurice on Sun Aug 13, 2017 4:48 pm

Many thanks JH
Maurice

Maurice

Posts : 88
Join date : 2010-05-08

Back to top Go down

Re: Villiers X1VA Engine

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum