Latest topics
» cruiser 80 brakes
Today at 12:10 am by intrudin

» oil seals for mid 50s rear shocks
Sun Feb 18, 2018 9:07 pm by bill2b

» oil seals for mid 50s rear shocks
Sun Feb 18, 2018 7:37 pm by bill2b

» More carb problems
Sun Feb 18, 2018 7:26 pm by Sgtbiro

» trials shake down run( a few teething problems) bike and rider
Sun Feb 18, 2018 7:26 pm by denman

» cruiser sports
Sun Feb 18, 2018 5:37 pm by sportscruiser

» Villiers gearbox dipstick for sale
Sun Feb 18, 2018 8:51 am by John Wakefield

» plating on falcon 67
Sat Feb 17, 2018 9:28 am by alan67

» 1954 Falcon 67
Thu Feb 15, 2018 10:51 pm by keith livingstone


1934 Cruiser model 39 stands

Go down

1934 Cruiser model 39 stands

Post  Graham M on Thu Jul 13, 2017 10:46 am

Hi there again,
I have a spark and have set the timing on my machine but need a local aluminium welder to repair a hole n the exhaust, should be interesting with 83 yo material.
Has anyone made a side and rear stand and have a drawing with dimensions as mine are missing or could anyone measure theirs or take some close up pictures and have the measurements from where the rear one pivots on the frame to the end that contacts the ground.
Thanks for your info so far.
Graham
avatar
Graham M

Posts : 30
Join date : 2017-06-05
Location : Australia

Back to top Go down

Rear stand

Post  Mollbhan on Thu Jul 13, 2017 10:04 pm

Hi Graham, I have a 38 Plover with the original working rear stand, if anybody can confirm they have the same stand I can give you some info. A good blacksmith could easily make one.
avatar
Mollbhan

Posts : 30
Join date : 2017-05-05

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum