Latest topics
» Francis Barnett Scrambler 94
Yesterday at 8:22 pm by piston 197

» For sale spares
Yesterday at 5:03 pm by kerabo

» Rear brake linkage
Yesterday at 5:00 pm by piston 197

» Falcon 87 - Big favour to ask.
Yesterday at 11:09 am by FB vincent

» Light Cruiser parts
Sat Dec 16, 2017 4:19 pm by mike Sayer

» Kestrel toolbox help
Sat Dec 16, 2017 3:04 pm by Simon75

» Membership
Sat Dec 16, 2017 1:24 pm by intrudin

» Bristol show 2018
Sat Dec 16, 2017 1:06 pm by piston 197

» Found a supplier with AMC rings
Fri Dec 15, 2017 5:48 pm by Cruiser79

Seagull electronic ignition and parts needed

View previous topic View next topic Go down

Seagull electronic ignition and parts needed

Post  JonTheBuilder on Thu Jun 15, 2017 8:34 am


I'm thinking go putting electronic ignition onto my 35 Seagull and was wondering if anyone had done the same and could recommend a kit to use?

Also I'm after a couple of parts. The tank is currently being held in place by gravity and the gear change lever! I'm after what I presume is a bracket/s which bolt under the tank onto the frame.
I also need the ball for the end of the gear change lever.

Any help would be great.



Posts : 2
Join date : 2017-06-11
Location : Guildford

Back to top Go down

Re: Seagull electronic ignition and parts needed

Post  Mike Neden on Sat Jun 17, 2017 8:14 am


I have a 35 Seagull, PM me your email address and I'll send some photos of how the tank fits. Essentially, there are two brackets welded to the bottom of the tank which bolt onto two brackets, which themselves are bolted to the top member of the frame. The tank also is supported by two bits of rubber at the front and back. I think later bikes had three fixing points.

Not sure about the electronic ignition, seems like a lot of messing about. Have you spoken to Villiers Services?



Mike Neden

Posts : 30
Join date : 2015-10-15

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum