Latest topics
» cruiser sports
Today at 5:37 pm by sportscruiser

» trials shake down run( a few teething problems) bike and rider
Today at 5:28 pm by piston 197

» oil seals for mid 50s rear shocks
Today at 5:01 pm by piston 197

» More carb problems
Today at 3:00 pm by kerabo

» Villiers gearbox dipstick
Today at 8:51 am by John Wakefield

» plating on falcon 67
Yesterday at 9:28 am by alan67

» 1954 Falcon 67
Thu Feb 15, 2018 10:51 pm by keith livingstone

» Carb problems.
Thu Feb 15, 2018 7:40 pm by Sgtbiro

» 1932?? Fanny B
Thu Feb 15, 2018 3:47 am by AussieFB


2T to 3T conversion

Go down

2T to 3T conversion

Post  cruiser5588 on Mon Aug 22, 2016 6:34 pm

Hi all,

Is it possible to fit a 3T top end to a 2T bottom end? I have a spare 2T engine and gearbox, and some 3T barrels and heads., and since Triumph 3TA and 5TA engines have the same bottom half...

Mike
avatar
cruiser5588

Posts : 13
Join date : 2016-03-05
Age : 70
Location : Hythe, Kent

Back to top Go down

3T to 2T

Post  piston 197 on Mon Aug 22, 2016 7:40 pm

Think from memory the crankcases of the 2T have to be opened out a little to take the bigger spigots on the bottom of the 3T cylinders ?

The 3TA and 5TA share the same crank, but you also have to change the Conrods so not quite the same bottom end ? Obviously you also need all of the top end to do the conversion ( Barrels, head, pistons etc.)

JH
avatar
piston 197
Moderator

Posts : 3745
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

2t 3T

Post  Bigjim on Sat Aug 27, 2016 5:32 pm

There is a change to the crankshaft sprocket which also means a new primary chain.  The fasteners for the inner chain case also change, this is to clear the bigger sprocket.  Also the steel barrel plates are different as will be some gaskets.
avatar
Bigjim

Posts : 140
Join date : 2016-06-13

Back to top Go down

2T to 3T

Post  cruiser5588 on Sun Aug 28, 2016 2:28 pm

Thanks for the response. I spoke to villiers services, and they confirm that the conversion is OK, provided you can get the rarer 3T barrels. Fortunately I have a pair, so the engine is now with them. They advise a little fettling of the steel plate, and to increase the gearbox sprocket by one tooth. Maybe also go up a main jet size. Heads are the same if low compression are fitted, if not, fit two head gaskets.

I look forward to a bit more torque.

Mike
avatar
cruiser5588

Posts : 13
Join date : 2016-03-05
Age : 70
Location : Hythe, Kent

Back to top Go down

Re: 2T to 3T conversion

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum