Latest topics
» New Francis Barnett
Yesterday at 7:11 pm by banjo boy

» Double lift centre stand
Yesterday at 3:25 pm by mike Sayer

» Best Oil to use
Sun Jan 21, 2018 10:16 pm by John Wakefield

» Plover Wiring
Sun Jan 21, 2018 7:27 pm by Rex Stewart

» Rear suspension
Sun Jan 21, 2018 5:25 pm by piston 197

» WELCOME TO THE FBOC FORUM
Sun Jan 21, 2018 4:34 pm by kerabo

» Newbie Here
Sat Jan 20, 2018 9:16 pm by MoscowFlyer

» Villers 14A seagul engine HELP
Sat Jan 20, 2018 8:14 am by JonTheBuilder

» pivot tube
Fri Jan 19, 2018 5:54 pm by ernie


13D Gearbox

View previous topic View next topic Go down

13D Gearbox

Post  seipgam on Thu Apr 21, 2016 1:18 am

Hi all,
If I remove the RH end plate (not just the outer cover) on my 13D gearbox, is there anything that is going to fall out or spring loose? Nothing broken or loose inside that I am aware of, just chasing an excessive oil leak. In a previous life the end plate looks to have cracked/broken and has been welded, now leaking. I have come across another end plate and I intend to swap it over.
Anything I should look out for, or any special procedure or tools required?
Clearly I haven't had it apart before so its all new to me.
I have the books with diagrams so I have something to follow if needed.

One thing to note- the 1st to 2nd change is a bit lazy/clunky, anything I should look for there while I have the end plate off?

Any help or clues would be appreciated.

Cheers, Geoff.
avatar
seipgam

Posts : 52
Join date : 2014-02-18
Age : 53
Location : Ballarat Australia

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum