Latest topics
» F/B 1957 Cruiser 75 Carbs
Today at 10:13 pm by Ianh

» Double lift centre stand
Today at 9:24 pm by Ianh

» 8e crankcase
Today at 9:00 pm by alan67

» VILLIERS 1H
Today at 8:14 pm by ScottT

» 8E Lighting Coils
Today at 2:38 pm by piston 197

» Farkle Garage
Today at 10:45 am by MoscowFlyer

» Falcon 67 Parts
Today at 10:05 am by TonyC

» Cruiser 1955
Yesterday at 9:56 pm by Ianh

» VILLIERS 1H
Yesterday at 9:17 pm by Ianh


wiring looms etc

Go down

wiring looms etc

Post  cruiser89 on Thu Jan 29, 2015 11:36 pm

Does anyone know where i can get a wiring loom for a 4T Cruiser 89 1964 fitted with the high output coils and twin switch set up in the headlamp, its an ex police bike.

Also regarding the alternator conversion on the 2T and 4T engines:

Peter Savage is not able to supply the parts he has been out of action since May 2014 following a stroke, i phoned him up a few days ago and spoke to his wife, he is still recovering from his stroke and is still not been able to make or supply any parts.

Is there anyone else who can make or supply the parts for the 12 volt conversion?

Cheers
Iain

cruiser89

Posts : 8
Join date : 2013-05-21
Location : Preston Lancashire

Back to top Go down

conversions

Post  kerabo on Fri Jan 30, 2015 8:41 am

Oh that's sad. I was wondering why I had no reply from Peter.
I wish him well.
I am pretty sure Villiers Services have conversions and also nametab .

Regards Ken
avatar
kerabo

Posts : 2229
Join date : 2008-02-11
Age : 67
Location : Falcon 87. Trials 93 Special. Powerbike 56. Falcon 81 Green Lane bitsa. Sunbeam S8. Honda Deuville.

Back to top Go down

harness

Post  andy-s on Fri Jan 30, 2015 10:18 am

Hi Iain, for a new harness you could try-

M E S Limited
Unit A2 Harris Road
Wedgnock Industrial Estate
Warwick
CV34 5JU
01926 499756

But i think you might have to have a diagram.
good luck Andy
avatar
andy-s

Posts : 124
Join date : 2012-09-17
Age : 50
Location : Frome

Back to top Go down

FB Cruiser 89 with 4T engine and high output generator

Post  FB vincent on Sat Jan 31, 2015 10:55 am

I have never been able to track down the full FB wiring diagram for these machines, which is probably unsurprising since they were only sold in small numbers to the police. FB (then at Greet) never even published an update to the Instruction Book when this engine was fitted from 1964. A Villiers 4T generic wiring diagram with the high output generator is available, but this does not show the headlamp switching; however, the wiring concept is the same as the Wipac arrangement for the Cruiser 80 with AMC engine, the coils being connected progressively when the ignition and then headlamp is on - all coils are connected in the 'E' position. Sandy

FB vincent

Posts : 623
Join date : 2009-01-20
Location : Hertfordshire

Back to top Go down

Re: wiring looms etc

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum