Latest topics
» pivot tube
Yesterday at 5:54 pm by ernie

» Double lift centre stand
Yesterday at 4:24 pm by FB vincent

» Contact breaker screw
Yesterday at 1:56 pm by jasperbell

» AMC 250CC CARB
Thu Jan 18, 2018 7:44 pm by MR SINBAD

» VILLIERS 1H
Thu Jan 18, 2018 9:37 am by piston 197

» 8e gear lever
Wed Jan 17, 2018 1:45 pm by kerabo

» help wanted
Tue Jan 16, 2018 8:20 pm by Dickey0-1

» Cruiser 75 Generator Coils
Tue Jan 16, 2018 7:38 pm by peter@dunfordconstruction

» ITEMS FOR SALE OR WANTED
Mon Jan 15, 2018 6:31 pm by bill2b


2t crankshaft

View previous topic View next topic Go down

2t crankshaft

Post  plugcap on Tue Jul 08, 2014 4:57 pm

Hi
How do you get to the center bearing on this crank it feels quite rough and in need of replacing, can it be split, I would be gratefull if i could obtain a engine parts list and manual for this engine.

plugcap

Posts : 37
Join date : 2013-10-16

Back to top Go down

manual

Post  kerabo on Tue Jul 08, 2014 5:50 pm

[u[/u
I have a used 2T 3T manual.looks like an original.  Bought it at a VMCC sale and won't need it . If you don't get sorted let me know.
I have never replaced the crank on these but am pretty sure the middle main is a specialist job
Regards Ken
avatar
kerabo

Posts : 2182
Join date : 2008-02-11
Age : 67
Location : Falcon 87. Trials 93 Special. Powerbike 56. Falcon 81 Green Lane bitsa. Sunbeam S8. Honda Deuville.

Back to top Go down

centre seal

Post  piston 197 on Tue Jul 08, 2014 6:35 pm

Have done it twice myself , with full engineering kit, truing jig, presses etc after the first time I thought I am not doing that again!, but after time eased the pain , did it a second time and it all came back !
You have to split one big-end, before you can part the centre webs, then you have to true it all up again , having pressed both the centre webs, and the big-end you split, back up to the original widths, Suggest you send the whole assembly to Nametab engineering, he will even do an exchange service 01527 522266 and then all big-ends, centre seal , outside seals and small ends are re-done JH
avatar
piston 197
Moderator

Posts : 3719
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

2t crankshaft

Post  plugcap on Wed Jul 09, 2014 8:42 am

Thanks for your advice , I think the best way is nametab saves me useing my hammer and chisel.
RJ

plugcap

Posts : 37
Join date : 2013-10-16

Back to top Go down

Re: 2t crankshaft

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum